|
|
|
Tank Management Solutions
> Tank Manager Probe
|
<< Return
|
Tank Manager Probe
|
The Tank Manager Double Barrel Probe is all solid state and uses ultrasonic technology to provide the most accurate system possible.The in-tank probe is designed to fit a range of tank sizes, with final adjustment to the particular tank made in the field with the sliding probe extension. The in-tank probe level sensor has no moving parts with the exception of the water detection float. All probes have the same characteristics with no field calibration required.
Principles of Operation: The in-tank probe is designed to fit a range of tank sizes, with final adjustment to the particular tank made in the field with the sliding probe extension. The in-tank probe level sensor has no moving parts with the exception of the water detection float. All probes have the same characteristics with no field calibration required.
 Location: The in-tank probe is installed in a 3-4 inch riser located close to the middle of the tank. Probe is assembled to fit tank. Specify tank diameter and riser height at order. Probe is connected to console with 4 conductor plus shield homerun cable. Probe sizes available to fit 2 feet to 12 feet diameter above ground and below ground tanks. Shipped with installation kit.
Note: The probe should be installed in the tank riser as close to the center of the tank as possible. The probe should rest firmly on the tank bottom. If the probe is installed in one end of the tank, you will have to adjust for tank tilt, if any, at the tank manager console.
Construction: The probe is made of sturdy fiberglass that withstands most hydrocarbon fuels. Contact factory for application in specific chemicals.
TMPROBE
Dimensions:
Diameter: 2 3/4"
Length: 2 to 12 feet
Contact us for more information.
|
|
|
|
|
